cocoaforge

COda is the brand new application from Panic software (creators of Transmit). Transmit is supported by Growl, do you think that it might be possible to add support for Coda, too?

http://www.panic.com/coda

We don't add support to applications; the applications' developers do. Let the folks at Panic know you'd like to see Growl support in their new program

evands wrote:We don't add support to applications; the applications' developers do. Let the folks at Panic know you'd like to see Growl support in their new program

Ah oky, I didn't know that I will do it right now.

I'd love support in Coda as well, so I'll be emailing them shortly, I'd suggest you do the same.

So their release notes state that Growl is supported since 1.0.2 - but where to set it up? Am I just too blind? In transfer prefs I can set sounds on finishing transfers but don't see any growl settings.

A lot of devs don't have any prefs for Growl in their software, it's just there. Does coda register with Growl on launch?

No hasn't registered upon start and release notes explicitly state Growl as new preference. Maybe it has something to to with Growl 1.1 which I'm using. No idea. Don't you have Coda to check if it's available there?

It shouldn't be svn, but give .7.6 a try with it. If it still doesn't work, go ahead and email them for support.

When using 0.7.6 the notifications are blurred. So I use svn.

I opened Coda and it registered. Make sure you have it set up to automatically install updates.

I downloaded 1.0.2 this morning and it's registered perfectly fine with my top of trunk build [that's 1.1 most fresh for those playing at home]

Well... I used 1.1(4168). And it didn't register. When downgrading to 0.7.5 it registered. Now I'm back using 1.1 and will compile build 4169 within the next minutes.

Thanks for any help.